COPING SLED PRO

When you need to make clean, smooth and precise profile cuts on the end grain of your rail pieces it can get a little hairy. The Fulton Rail Guide Coping Sled PRO has been designed to make this part of the cabinet door and drawer building process much easier and safer. No longer worry about your piece dipping to far into the router bit and even worse losing control. This sled will help you produce wonderful looking and fitting end grain cuts each and every time you use it!

When building cope and stick door and drawer fronts, one of the tasks that must be done is to cut the end grains of your rails. This sounds easy enough, however the narrower your rails are, the more difficult it is to hold the stock firmly up against a router table fence. Our Rail Guide Coping Sled Pro solves this issue and helps you make precise, square, clean cuts for rail and style doors, drawer fronts and most any other type of end grain cut on your router table.

The idea behind the Rail Guide Coping Sled Pro is simple; hold your rails firmly at a 90 degree angle to your router table fence so you can feed your stock through the cutter for the cleanest, squarest cuts possible. When doing drawer fronts which often times use very narrow rails, this sled will prevent your stock from dipping or pushing in too far and also keeps your hands away from harm.

To see pdf instructions:
https://www.ptreeusa.com/PDF/2943_PDF_instructions.pdf