SO-HW R4 OFK CUTTER - ROUTER

Fits OFKC500 Cordless Edge Router

This round-over router bit is designed for clean, precise edge profiling on both plastic edge banding and solid wood. It delivers smooth, consistent results for a refined edge finish on small and detailed workpieces. Its hollow, direct-thread design mounts straight onto the trim router shaft—no collet required—for stable, wobble-free cutting and excellent run-out accuracy. The result is a smooth, uniform round-over and a clean routing pattern with minimal setup and maximum control.
Two cutting edges: Dual carbide cutting edges provide longer life and consistent cutting performance
Round-over profile: Designed for clean, uniform edge rounding
Precision-ground radius: Ensures smooth, accurate profiles and a consistent finished edge
Low profile design: Allows routing in rabbets or across stacked panels
Surface protection: The radius transitions into a 5° relief angle for smoother exits and reduced surface marking
Ball bearing not included
Collet-free, hollow-shaft design
Carbide-tipped design

Specifications
R 1/8" (3 mm)
D 1-1/16" (27 mm)
No. of teeth 2.00