1/2 in. Drill Chuck #2MT

1/2 in. Drill Chuck #2MT

Product Description
#2 Morse taper for Delta and Jet lathe headstocks or tailstocks. A 1/2" grip can be used for grabbing small turnings or pen mandrels on the headstock or a drill bit in the tailstock.

Note that to use in the headstock, it must be used with a drawbolt. Draw bolts can only be used with lathes that have a through hole in the headstock. They are threaded into the taper and are kept in place with a washer and nut on the back end of the headstock. Thread size is 1/4 x 20tpi or 6mm x 1.0.