SO-Sauter Pivoting Router Lift

Imagine being able to set your router bits to any angle up to 50 degrees. Now you can with the Sauter OFL3.0 Pivoting Router Lift exclusively from MicroJig. This German-made router lift that can pivot from -5 degree to+50 degrees as well as move front to back to accommodate the angle settings so your ‘common’ router bits can do amazing things.

This German made system includes a Swiss made 2hp router, three throat plates, wrenches and collets in both 1/4’ and 1/2"" collets, everything you need to get started. Attached to your router table it brings the capabilities
of an industrial tilting shaper to your shop for a fraction of the cost.

What could you do if 90 degrees is not the only setting for your router table?
With the Sauter OFL3.0 Pivoting
Router Lift, exclusively from MicroJig, your ‘regular’ router bits can be set to any angle from -5 degrees to +50
degrees of angle.

This German made lift fits any router table with the standard 11-3/4” (300mm) by 9-1/4”
(235mm) plate opening and comes with a 2hp Swiss made router.


Any straight bit can now cut chamfers at any angle up to 50 degrees, and slot cutters can make the matching spline cut at the same angle.

Drawer Pull bits can be used at the 20 degree angle they were designed for along with a range of other milling options not readily available.



You supply the router table of your choice, and MicroJig supplies the rest;



• Router lift with tilt, height and position adjustments


• 2hp Swiss made router motor with variable speed from 3,500 to 30,000 rpm


• Three throat reducing plates for various sized bits


• All wrenches and tools needed

• 1/4"" and 1/2"" collets

This is the only complete router tilt system on the market and will give your shop capabilities only previously available from industrial level tilting arbor shapers.

Tilt any bit up to 50° - straight bits become chamfer bits, profile bits multiply into new shapes, and angle-designed bits finally run as intended: shaper capability at your router table.

Every angle, repeatable - snap-in presets at 15°, 22.5°, 30°, and 45° across the full –5° to +50° range, with a vernier scale for everything between.

Bit changes stay easy - the lift travels fore and aft to keep the bit centered in the throat opening at any angle, and every adjustment is 100% tool-free.

The only complete system on the market - Swiss-made - 2 HP variable-speed motor (3,500–30,000 RPM), 1/4" and 1/2" collets, three magnetic throat plates, wrenches, and an undermounted dust shield included.

Drops into your table - machined-aluminum plate with leveling screws fits the standard 11-3/4" × 9-1/4" opening, commercial or shop-built.

Smooth, precise, German-made - Sauter precision engineering on every tilt, travel, and height move.